Table of Contents
Advertisement
Serial (RS-232-C) Cable Pin Assignments
Cubiscan 110-XT
This appendix contains the cable pin assignments for the interface
between the Cubiscan 110-XT and a host computer via a serial RS-232
connection as well as for the interface between the Cubiscan 110-XT and a
network via an Ethernet TCP/IP connection.
The communications command set can be found in a separate document
titled Cubiscan 110-XT Communications Command Set.
The Cubiscan 110-XT serial ports use the EIA RS-232-C communications
protocol. The data are serially transmitted ASCII characters.
The following table shows the serial connector pin assignments. All other
pins are not connected.
RS-232-C Male DB 9-Pin Assignments
Pin
Signal
Pin 2
RXD
Pin 3
TXD
Pin 5
SGND Signal ground (DB-9 connector)
The following table shows the parameters for asynchronous
communications through the RS-232 serial cable.
COMMUNICATIONS
Description
Commands from the host computer
Data from the control unit to the host
Asynchronous
Communication Parameters
Baud Rate
9600
Parity
None
Data Bits
8
Start Bits
1
Stop Bits
1
Appendix A
64
Advertisement
Table of Contents
