Setting Up The Back Panel; Figure 5 Keyhole With Tightened Screw - Quantronix Cubiscan 110-XT Operation And Technical Manual

Table of Contents

Advertisement

Setup

Setting up the back panel

Cubiscan 110-XT
A Phillips screwdriver will also be needed to assemble the Cubiscan
110-XT.
Take the following steps to attach the back panel.
1. Loosen the four screws on the back edge of the platform with a Phillips
screwdriver.
2. Place the backplate keyholes over the loosened screws, slide the plate
down, and secure the screws.
Figure 5
Keyhole with tightened screw
Setting up the back panel
9

Advertisement

Table of Contents
loading

Table of Contents