Operation; Before You Begin - Quantronix Cubiscan 110-XT Operation And Technical Manual

N
OTE

Before you begin

N
OTE
N
OTE
WARNING
Cubiscan 110-XT
This chapter provides instructions for operating the Cubiscan 110-XT.
The platform of the Cubiscan should be kept clean and free of objects that are not
being measured.
Follow the procedures below to turn on the Cubiscan. The Cubiscan should
be turned on before you start Qbit (if applicable).
1. Make sure there are no packages or objects on the Cubiscan platform.
2. Turn on the Cubiscan 110-XT via the power strip. The Cubiscan
performs diagnostic procedures that take about five seconds. Do not
touch the Cubiscan platform during these five seconds.
Do not lean on or touch the Cubiscan platform or the package while a package is
being cubed and weighed. Any kind of contact with the platform during the
measurement process can alter the weight or sensor reading.
You should occasionally verify that the zero settings on the Cubiscan are correct.
To do this, take a measurement with nothing on the scale and see if all values
recorded are zero. The Cubiscan's empty weight and measurements can be reset
to zero (zeroed) at any time (refer to the Qbit User Guide or to
Cubiscan 110-XT" on page
Disconnect all power to the Cubiscan 110-XT before servicing or making any
connections.

OPERATION

26).
CHAPTER 3
"Zeroing the
22