Table of Contents
Advertisement
Troubleshooting
Computer error messages
No
communication
with Cubiscan
Transmission
error
About
Version
Cubiscan 110-XT
2. Move the Cubiscan if it is located close to open freight doors or where
hot air is blowing on it. Extreme changes in temperature and humidity
can affect the accuracy of the Cubiscan 110-T. Refer to
page
14.
3. Recalibrate the Cubiscan. Refer to
The following error messages generated by Qbit indicate a
communications problem between the Cubiscan and the computer.
This message indicates that no communication is taking place between the
computer and the Cubiscan 110-XT.
This message indicates that erroneous data or garbled data is being sent
from the Cubiscan.
If you receive one of these messages, verify the following.
1. Is the Cubiscan turned on and securely connected to power?
2. Is the USB, serial, or Ethernet cable securely connected?
3. Is there a problem with the Cubiscan 110-XT? Perform the Status
function in Qbit to check the status of the Cubiscan.
4. Is there a problem with the computer or network? Refer to your
computer manual for information on troubleshooting the computer, or
contact your network administrator.
This section describes the About menu of the Cubiscan 110-XT. The
menu contains useful information and records of the Cubiscan 110-XT.
This section discusses the options available on the version menu.
Complete the following steps to access the version menu.
Computer error messages
"Placement" on
"Calibration" on page
38.
About
52
Advertisement
Table of Contents
