Snap-On TECHANGLE STEEL MICRO Manual page 20

Electronic torque-angle wrench
Table of Contents

Advertisement

4. Use UP
/DOWN
5. Use UP
/DOWN
6. SET TIME screen is displayed with Hour highlighted.
7. Use UP
/DOWN
8. Use UP
/DOWN
9. Use UP
/DOWN
10. Clock is set and Configure menu is displayed.
JOB MODE
CALIBRATION
SET DATE/TIME
ENTER button
Note: Year selection will scroll up from 2014. Month selection will scroll from 1 to 12. Day selection
will scroll from 1 to 31.
Note: Hour selection will scroll through 0 to 23. Minute and Second selections will scroll through 0 to
59.
Note: If batteries are removed from wrench for longer than 20 minutes, clock will revert to default
settings and must be re-entered at power on.
Setting Calibration Interval
This function will allow user to set calibration interval for when "CAL NEEDED" message will be
displayed.
1. From Configure menu, use UP
then press ENTER
2. CAL INTERVAL screen is displayed.
3. Use UP
/DOWN
Selectable Intervals:
 DISABLED (factory default)
 3 MON
 6 MON
 12 MON
4. Press ENTER
CALIBRATION
SET DATE/TIME
SET CAL INTRVAL
ENTER button
Note: Clock Date and Time must be set before calibration interval will function. If batteries are removed
from wrench for longer than 20 minutes, clock will revert to default settings and must be re-
entered at power on.
buttons to set month then press ENTER
buttons to set day then press ENTER
buttons to set hour then press ENTER
buttons to set minutes then press ENTER
buttons to set seconds then press ENTER
ENTER
SET DATE
button
2017/01/01
YR MON DAY
UP/DOWN buttons
SET TIME
12
: 30 : 00
HR MIN SEC
UP/DOWN buttons
/DOWN
button.
buttons to change calibration interval.
button to accept selection and exit to Configure menu.
CAL INTRVAL
ENTER
button
DISABLED
EXIT
UP/DOWN buttons
CAL INTRVAL
12 MON
EXIT
ENTER
SET DATE
button
2017/01/01
YR MON DAY
UP/DOWN buttons
ENTER button
ENTER
SET TIME
button
12 :
30
: 00
HR MIN SEC
UP/DOWN buttons
buttons to highlight
19
button to highlight day.
button.
button to highlight minutes.
button to highlight seconds.
button.
ENTER
SET DATE
button
2017/01/01
YR MON DAY
UP/DOWN buttons
ENTER
SET TIME
button
12 : 30 :
00
HR MIN SEC
SET CAL INTRVAL
selection

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TECHANGLE STEEL MICRO and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF