Sleep Time - Snap-On TECHANGLE STEEL MICRO Manual

Show Info
Show Info menu selection displays wrench operational information.
1. From Settings menu, press ENTER
2. SHOW INFO screen is displayed.
3. UP /DOWN


Operational Information:
 CAL: Date of last wrench calibration.
 ISD: In-Service Date.
 TCF: Torque Calibration Factor.
 ACF: Angle Calibration Factor.
 VER: Software version.
 OVR CNT: Overtorque Counter tracks how many times an over-torque event occurred on
wrench (torque >125% of full scale).
 TQZ: Torque Zero Offset.
 AZZ: Angle Z-Axis Zero Offset.
 AXZ: Angle X-axis Zero Offset.
 Copyright
4. Pressing ENTER
EXIT
SHOW INFO

SLEEP TIME

ENTER
button
Setting Sleep Time
This function will allow user to set interval wrench enters power-down state following last applied
torque or button press.
1. From Settings menu, use UP

ENTER button.

2. SLEEP TIME screen is displayed.
3. Use UP /DOWN


Selectable Intervals:
 2 MIN (factory default)
 5 MIN
 10 MIN
 30 MIN
 1 HR
 2 HR
 8 HR

4. Press ENTER


buttons are used to scroll screen.



button exits Show Info screen and returns to Settings menu.

ENTER
SN: 0417500366
button
CAL: 2017/01/01
ISD: 2017/01/01
UP/DOWN buttons
AXZ: 157
CAL: 2017/01/01
© 2017 SNAP-ON
 /DOWN

buttons to select sleep interval.


button to accept selection and exit to Settings menu.
button while SHOW INFO

 buttons to highlight

12
selection is highlighted.
SLEEP TIME selection then press