Snap-On TECHANGLE STEEL MICRO Manual page 11

00
90°
Target Angle Screen
ENTER button
04
PSET 02
90°
Preset Angle Screen
Editing a Preset
Edit PSET function gives user ability to edit stored PSETS on wrench.
1. From Preset screen to be edited, press and hold UNITS
2. CHANGE PRESET screen is displayed.
3. Highlight EDIT selection using UP
4. MINIMUM TORQUE or ANGLE screen is displayed. Value can be changed by pressing
UP  /DOWN


ENTER button.

5. MAXIMUM TORQUE or ANGLE screen is displayed next. Value can be changed by pressing
UP  /DOWN


ENTER button.

6. BATCH COUNT screen is displayed next. Value can be changed by pressing UP
buttons. Once desired batch count value has been set, press ENTER
7. PSET target screen is displayed labeled with same PSET number.
00
90°
Target Angle Screen
ENTER button
00
PSET 02
92°
Preset Angle Screen
Note: Pressing ENTER
PSET.
Deleting a Preset
Delete PSET function allows user to remove stored presets from wrench.
1. From Preset screen to be deleted, press and hold UNITS
2. CHANGE PRESET screen is displayed.
3. Highlight DELETE
4. Target screen is displayed and deleted PSET is no longer available for selection.
UNIT
ADD PRESET
button
held YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
ENTER button

 buttons. Once desired target torque or angle value has been set, press
 buttons. Once desired target torque or angle value has been set, press

UNIT
DELETE
button
held EDIT
EXIT
UP/DOWN buttons
DELETE
EDIT
EXIT
ENTER button

button while

menu selection using UP
UP/DOWN buttons
ENTER
MINIMUM ANGLE
button
90°
U
/DOWN  buttons then press ENTER
 
UP/DOWN buttons
ENTER
MINIMUM ANGLE
button
92°
EXIT menu selection is highlighted will exit without editing
 /DOWN 

10
UP/DOWN buttons
ENTER MAXIMUM ANGLE
button
94°
ENTER
button
BATCH COUNT
4
UP/DOWN buttons
button for 3 seconds.


button.

UP/DOWN buttons
ENTER MAXIMUM ANGLE
button
94°
ENTER
button
BATCH COUNT
0
UP/DOWN buttons
U button for 3 seconds.
buttons and press ENTER

button.

 /DOWN 
 

button.
