SOLTEK 85MR3 Manual page 49

85MR3 / 85MR3-L
(Hyper-threading If hyper-threading CPU is running on board, this item
Function) appears to show the enabled status.
Choices: Enabled; Disabled
SDRAM Frequency Allows you to set the SDRAM frequency.
Choicesfor 100MHz CPU: Auto; 200MHz; 266MHz
Choices for 133MHz CPU: Auto; 200MHz;266MHz;
333MHz
Configure SDRAM SPD (Serial presence detect) is a device in memory
Timing by SPD module for storing the module information such as
DRAM timing and chip parameters. If this option is
enabled, BIOS will access SPD automatically to
configure module timing. If disabled, DRAM timing
can be configured manually.
SDRAM CAS# Latency With SDRAM Timing by SPD disabled, you can se-
lect the SDRAM CAS# (Column Address Strode)la-
tency manually.
Choices: 2Clocks; 2.5 Clocks
SDRAM RAS# With SDRAM Timing by SPD disabled, you can se-
Precharge lect the SDRAM RAS# (Row Address Strode)
Precharge cycle manually.
Choices: 2Clocks; 3 Clocks
SDRAM RAS# to With SDRAM Timing by SPD disabled, you can se-
CAS# Delay lect the SDRAM RAS# to CAS# delay cycle
manually.
Choices: 2Clocks; 3 Clocks
SDRAM Precharge Allows you to set the SDRAM Precharge Delay
Delay cycle.
Choices: 5 clocks; 6 clocks; 7 clocks
SDRAM Burst Length With SDRAM Timing by SPD disabled, you can se-
lect the SDRAM Burst length manually.
Choices: 8; 4
72