Table of Contents
Advertisement
Operation
• Do not charge a frozen battery.
• Do not abuse the cord. Do not carry the charger
by the cord or yank on the power supply cord to
disconnect the charger from the receptacle. Keep
the cord from heat, oil, and sharp edges.
• Connect the charger directly to a grounding
receptacle. Do not use the charger on an
ungrounded outlet, even with a grounding
adapter.
• Do not alter the provided power cord or plug.
• Remove metal items such as rings, bracelets,
necklaces, and watches when working with a
lithium-ion battery. A lithium-ion battery can
produce enough current to cause a severe burn.
• Never operate the charger without good visibility
or light.
• Use an extension cord capable of handling 15 A
or more. If you are charging outdoors, use an
extension cord rated for outdoor use.
• If the power supply cord is damaged while it is
plugged in, disconnect the cord from the wall
receptacle and contact an Authorized Service
Dealer for a replacement.
• Unplug the charger from the electrical outlet
when not in use, before moving it to another
location, or prior to servicing it.
Maintenance and Storage
• Store the charger indoors in a dry, secure place
that is out of the reach of unauthorized users.
• Do not disassemble the charger. Take the charger
to an Authorized Service Dealer when service or
repair is required.
• Unplug the power cord from the outlet before
starting any maintenance or cleaning to reduce
risk of electric shock.
• Maintain or replace safety and instruction labels
as needed.
• Do not operate the charger with a damaged cord
or plug. Contact an Authorized Service Dealer to
obtain a replacement cord.
• If the charger has received an impact, been
dropped, or otherwise damaged, do not use it;
take it to an Authorized Service Dealer.
Moving a Non-Functioning Machine
Important: Do not tow the machine without
first disengaging the transmission, otherwise you
could damage motor components.
CAUTION
The machine does not have brakes when
the transmission is disengaged. It will roll
uncontrolled, possibly causing injury.
If you must tow the machine, install the Tow
Bar Assembly Kit to prevent the machine from
colliding with the towing vehicle. Contact your
Authorized Service Dealer to obtain the kit.
1.
Disengage the PTO and move the motion-control
levers outward to the Park position.
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the cap from the motor.
1. Motor cap
4.
Insert a ratchet with a 3/8 inch drive into
the square hole in the motor hub. Rotate it
counterclockwise until it stops (approximately
4 full rotations) to disengage the transmission.
Torque to 41 to 68 N∙m (30 to 50 ft-lb).
Note: The wheel will spin freely.
29
Operation
Figure 34
g398424
Advertisement
Table of Contents
