Table of Contents
Advertisement
Operation
Adjusting the Battery Percentage for
Limp Mode
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the Park position.
2.
In the Main menu, scroll down to Service and
press the
button.
3.
In the Service menu, scroll down to Limp Mode
and adjust the percentage using the – and +
buttons.
After Operation
After Operation Safety
• Disengage the PTO whenever you are
transporting or not using the machine.
• Use full-width ramps for loading the machine into
a trailer or truck.
• Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
• Replace all worn, damaged, or missing parts and
decals. Keep all fasteners tight to ensure that the
machine is working properly.
Figure 32
Figure 33
Battery and Charger Safety
General
•
WARNING: Risk of fire and electric
shock—The batteries have no user-serviceable
parts.
• Confirm the voltage that is available in your
country before using the charger.
• Do not get the charger wet; keep it protected
from rain and snow.
• A risk of fire, electric shock, or injury may result
from using an accessory not recommended or
sold by Exmark..
• To reduce risk of a battery explosion, follow
g376300
these instructions and the instructions for any
equipment that you intend to use near the charger.
• Batteries could emit explosive gasses if they are
significantly overcharged.
• Refer to an Authorized Service Dealer to service
or replace a battery.
Training
• Never allow children or untrained people to
operate or service the charger. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
g377943
• Read, understand, and follow all instructions on
the charger and in the manual before operating
the charger. Be familiar with the proper use of
the charger.
Preparation
• Keep bystanders and children away while charging.
• Wear appropriate clothing while charging,
including eye protection; long pants; and
substantial, slip-resistant footwear.
• Shut off the machine and wait until the machine
has completely powered down before charging.
Failure to do this may cause arcing.
• Ensure that the area is well ventilated while
charging.
• The charger is for use on only nominal 120 to
240 VAC operation. For use with 240 V circuits,
contact your Authorized Service Dealer for the
correct power cord.
28
Advertisement
Table of Contents
