Exmark VERTEX V Series Operator's Manual page 41

Checking the Wheel-Lug Nuts
Service Interval: After the first 100
hours—Check the
wheel-lug nuts.
Check and torque the wheel-lug nuts to 75 to 88 N∙m
(55 to 65 ft-lb).
Changing the Transmission Fluid
Service Interval: After the first 50 hours
Every 500 hours
Fluid type: Exmark Synthetic Electric Motor Drive
Oil
Capacity: 150 mL (5 fl oz)
1. Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the Park position.
2. Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the tire.
4. Place a drain pan under the transmission.
Figure 50
5. Remove the top plug and bottom plug. Allow the
fluid to drain.
6. Install the bottom plug and torque it to 7 to 8
N∙m (62 to 70 in-lb).
7. Remove a side plug.
8. Add fluid, as specified at the beginning of this
procedure, through the top hole until the level
reaches the side plug opening.
9. Install the top plug and side plug . Torque them
to 7 to 8 N∙m (62 to 70 in-lb).
g380066
10. Install the tire and torque the lug nuts to 75 to
88 N∙m (55 to 65 ft-lb).
11. Repeat for the other transmission.
41
Maintenance
Figure 51
Figure 52
g380054
g380053