Table of Contents
Advertisement
Maintenance
Adjusting the Tracking
If you push both motion-control levers forward the
same distance and the machine pulls to 1 side, adjust
the tracking as follows.
Note: The message display shows only 2 items at
a time; however, the following figures show the full
menus for context.
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the Park position.
2.
In the Main menu, scroll down to Service and
press the
button .
3.
In the Service menu, scroll down to Tracking and
press the
button.
4.
Adjust the tracking to the left or right.
Note: Adjusting the tracking to the left causes
the machine to steer toward the left; adjusting the
tracking to the right causes the machine to steer
toward the right.
Figure 60
Figure 61
5.
Press the
Adjusting the Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the motion-control levers.
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the Park position.
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Turn the battery-disconnect switch to the Off
g376300
position.
4.
Push the motion-control levers down out of the
Park position.
1. Left motion-control lever
g426844
2. Right motion-control
lever in the Park position
5.
Check the horizontal alignment of both levers by
using the front or rear reference bar as a guide.
Note: If a lever is not aligned, proceed to step 6
to adjust the cam for that lever.
6.
Release the cushion from the rear of the machine
and remove the rear access cover.
7.
Loosen the bolt holding the cam.
44
Figure 62
button.
Figure 63
3. Check the horizontal
alignment here
4. Right motion-control
lever
g377650
g376309
Advertisement
Table of Contents
