Led Indication - Siemens SSD161S.05DU Manual

DC 0...10 V control signal (for SSD161S.25DU, SSD161S.05DU)
● The valve opens / closes in proportion to the con-
trol signal at Y. The SSD161... actuators can be
set to either a linear or equal percentage control
signal response, depending on the position of the
associated flow characteristic DIP switch.
● At DC 0 V, actuator stem will be either extended or
retracted, resulting in the valve being either fully
closed or open, depending on the position of the
associated direct/reverse acting DIP switch and
whether the valve is a normally open or normally
closed valve.
● When no power is supplied, the SSD161S.05DU
actuator maintains its current position and the
SSD161S.25DU fails with either the stem fully
retracted or fully extended, depending on the
position of the associated fail up/fail down DIP
switch.
● This actuator provides a DC 0...10 V position
feedback signal proportional to the stroke of the
actuator stem.
Y = Control signal Y [V]
H = Percentage of calibrated valve stroke

LED indication

Modulation: Stem
Modulation: Stem
Stem position
Manual operation
Ultra-cap initial
* Only available for SSD161S.25DU, SSD131.29U
Siemens
Smart Infrastructure
Status
Variants
retracting
extending
At H0 (fully extended or fully retracted based on position of direct/reverse acting DIP
At H60 to H100 (fully retracted or fully extended based on position of direct/reverse acting
Fail-safe*
Calibration
Error
Flashing green/red alternatively (LED2): Green 500 ms, red 500 ms
charging*
LED indication patterns
SSD161S.05DU, SSD161S.25DU, SSD131.29U
Flashing green in sequence: LED1-->LED2-->LED3 (500 ms each)
Flashing green in sequence: LED3-->LED2-->LED1 (500 ms each)
switch) to H40: Constant green (LED3)
At H40 to H60: Constant green (LED2)
DIP switch): Constant green (LED1)
Flashing red (LED2): 500 ms on, 500 ms off
Flashing green (LED2): 100 ms on, 100 ms off
Constant red (LED2)
Constant green & red simultaneously (LED2): Constant orange
3
A6V12681520_enUS_a
02/09/2023