PANDROL CD200 IQ Operation And Maintenance Manual page 31

5.3.4. Automatic de-clipping (Fig 26)
This is the common mode during de-clipping.
1. Press the button (2) to select automatic mode "Auto".
2. Press the button (1) to select de-clipping mode "Ext".
3. Pull and hold the dead man's grip.
Press and release the button (5) to perform de-clipping.
The de-clipping arms will retract automatically.
5.3.5. Sleeper lift
1. Release the dead man's grip to lower the tool against
the rail.
2. Press and hold the button (5) until the tool is pressed
against the clips.
3. Verify that the tool is fully attached to both clips. Pull
the dead man's grip to lift the tool.
4. Release the button (5) as soon as the clip is installed.
The clipping arms will retract automatically.
5.3.6. Dead man's grip
The dead man's grip shall be hold against the handle bar
during normal operation. This will enable tha machine
to rest onto the support wheel. The machine will lower
to the ground to avoid uncontrolled movement if the
operator release the dead man's grip. Release thee
deam man's grip to lift low positioned sleepers.
OPERATION AND MAINTENANCE MANUAL I ENG_OMM_CD200IQ_P03 I 2023-03-16
@Pandrol 2023
31 av 82