Table of Contents
Advertisement
Available languages
Available languages
EN
WEEKLY PROGRAMMES
It is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade
from 24hr mode (factory default) to 24hr/7days mode as follows:
Move the selector to
position maintaining the
been set.
SETTING THE DAY: Press the
correct number, if required, by pressing
again the
key and new values will be stored.
To check a programme or to make a new one press
the display will show
dia1
shows again
. Repeat this process with the 7 days of the week. When the display shows
program will be stored by pressing + key.
If the display shows
and so on.
It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the
relevant
To turn back a controller from 24hr/7days to a single 24hr press
factory default settings.
KEYBOARD LOCK
Press the
key more than six seconds and the keyboard will be locked. The display will show
controller will keep on working internally. To unlock the keyboard, press again the
SUN MANUAL OVERRIDE
In programming mode, the heater will maintain the sun temperature set point and will ignore the pre-set program
until the next change in programming temperature level.
Maintain the SUN Key pressed for 4 seconds in programming mode to set the Sun Manual Override. Both luminous
indicators SUN and MOON will be lit. This function could be useful when SUN temperature is required and we do not
want to modify the program.
By pressing the SUN key for 4 seconds with Sun Manual Override activated, the function will be removed and the
heater will follow the programme again.
4.- ADVANCED FUNCTION
OPEN WINDOW DETECTION
0
position, the display will be Off. Press the
key at least five seconds. The display will show
key more than two seconds and the display will show the number of the day. Set the
+
or
00:00
intermittently. Follow now the steps from DAILY PROGRAMMES section until the display
dia1
then, pressing + key more than three seconds will copy the day 1 program to day 2
key until an audible signal is heard.
key and at the same time turn the selector to
–
keys. Press the
key and the display will show now the time. Press
PRG
key: The display will show
PRG
key more than six seconds. This will restore the
20
P-SE
which means that weekly mode has
dia1
. Press again
dia7
key more than six seconds.
P
PRG
key and
the weekly
and the
Advertisement
Table of Contents
