Table of Contents
Advertisement
4.8
CAN
The COMe-mTT10 optionally supports the EG20T implemented CAN interface as defined in COM Express® specification on
Pins Pins A101/A102 instead of UART1. To connect the CAN interface from the module to the CAN bus, it is necessary to
add transceiver hardware on the Carrier Board.
CAN Controller features:
» CAN Protocol Version 2.0B Active
» Supports bit rate up to 1Mbit/second
» Supports 32 message objects
» Programmable FIFO
31
COMe-mTT10 / Features and Interfaces
Advertisement
Table of Contents
