Table of Contents
Advertisement
Failure
Heating stops suddenly
during operation and the
display flashes "u".
Heating zones of the same
side ( Such as the first and
the second zone ) would
display "u" .
Fan motor sounds abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction hob.
9. INSTALLATION
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work
surface material (Wood and similar fibrous or hygroscopic material shall not be used as work surface material
unless impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from
the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop should
be at least 3mm.
Copyright © 2019, Fast ČR, a. s.
Problem
Pan Type is wrong.
Pot diameter is too
small.
Cooker has overheated;
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
Solution A
Use the proper pot
(refer to the instruction
manual.)
Unit is overheated.
Wait for temperature to
return to normal.
Push "ON/OFF" button to
restart unit.
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
Solution B
Pan detection
circuit is damaged,
replace the power
board.
EN - 19
Revision 05/2020
Advertisement
Table of Contents
