Table of Contents
Advertisement
PART 8. INSTALLATION
8.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 50mm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work
surface material (Wood and similar fibrous or hygroscopic material shall not be used as work surface material
unless impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from
the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop should
be at least 3mm.
L (mm)
W (mm)
590 mm
520 mm
EN - 18
Copyright © 2019, Fast ČR, a. s.
H (mm)
D (mm)
55
51
A (mm)
B (mm)
560+4
490+4
+1
+1
SEAL
X (mm)
F (mm)
50 mini
3 mini
Revision 10/2021
Advertisement
Table of Contents
