Table of Contents
Advertisement
(*) When the display shows alarm A1, the "water
tap" indicator also lights up ("E" - Table 2 "Control
panel").
I8
Machine cleaning
Cleaning must be carried out after every day of use.
Use hot water, a neutral detergent/detersive if neces-
sary, and a soft brush or sponge. If another type of
detergent is used carefully follow the manufacturer's
instructions and observe the safety rules given in the
information cards provided with the product or sub-
stance.
In order to reduce the environmental impact of pollut-
ant substances, clean the equipment (externally and
internally where necessary) with products that are
more than 90% biodegradable.
CAUTION!
Do not use steel wool or similar mate-
rial to clean s/steel surfaces. Do not
use detergents containing chlorine.
IMPORTANT!
Do not clean the machine with jets of
water.
CAUTION!
Contact with chemical substances (e.g.
detergent, rinse aid, scale remover,
etc.) without taking appropriate safety
precautions (e.g. personal protection
equipment) can involve exposure to
chemical risk and possible damage to
health. Therefore always refer to the
safety cards and labels on the products
used.
I8.1
End of service and daily internal cleaning
The appliance is designed to carry out an automatic
cleaning cycle to help flush out any residues and to
guarantee greater health and hygiene:
•
Lift the hood and take out the rack containing the
clean dishes.
•
In versions with supplementary filtering system
(FS), remove the basket filter "1", the flat filter "2",
the tank filter "3" and the pump suction filter "4" ("A"
- Figure 25).
•
In versions without supplementary filtering system
(FS), remove the flat filter "1", the overflow "2" and
the pump suction filter "3" ("B" - Figure 25).
.
A
Figure 25 Filters and overflow
•
Close the hood.
•
Select the drain cycle by pressing button "M"
(Table 2 "Control panel").
The message "CLE" ("CLEAN") will be displayed
throughout the drain cycle:
•
After a few minutes, 3 beeps indicate the end of
thecleaning cycle and "END" blinks on the display:
•
Switch off the dishwasher by pressing button "A"
(Table 2 "Control panel").
•
Switch off at the mains.
•
Close the water supply valve.
•
Replace the filter and the overflow.
Cleaning the nozzle jets
•
Remove the upper and lower wash arms "F" and
rinse arms "I", undoing the ring nut "H" (Figure 26).
H
Figure 26 Wash and rinse arms
•
Carefully clean the washing and rinse jets and
clean everything with hot water and neutral deter-
gent/detersive, if necessary using a soft brush or
1
2
3
1
4
2
B
3
F
I
31
Advertisement
Table of Contents
