Table of Contents
Advertisement
LEGEND
WI =
Water inlet
M1 =
Wash pump
M3 =
Rinse pump
E6.2
Installation diagrams
The following installation diagrams give the machine overall dimensions and position of water and electrical connec-
tions.
IMPORTANT!
Make sure to install an extractor hood to remove the steam produced by the machine.
The hood air flow must be calculated taking into account the type of installation and the work
environment where it is installed. In any case, an air flow rate of between 1000 m
h is recommended.
Plumbing circuit diagram - manual hood type with drain pump
M4 =
Drain pump
AG =
Air Gap
YV1 = Filling solenoid valve
3
3
/h and 1500 m
/
15
Advertisement
Table of Contents
