Electrolux EHT60XLG User Manual page 23

Press the button ("L" - Table 2 "Control panel") twice to
access the detergent and rinse aid adjustment para-
meters.
The display shows dun which is the first parameter of
the dispenser family:
Parameter description
Unit of measure of dispensers
(G-L= g/l or SEC= seconds)
Initial amount of detergent
Initial amount of rinse-aid
Amount of detergent during
the cycle
Amount of rinse-aid during the
cycle
(*) The values given in the table refer to the factory-
settings.
1. Use the Wash cycle 1 ("G" - Table 2 Control panel)
and Wash cycle 2 ("H" - Table 2 Control panel) but-
tons to select the parameter to modify.
2. Press the button ("L" - Table 2 Control panel) to
modify the parameter value.
3. Press the Wash cycle 1 ("G" - Table 2 Control
panel) and Wash cycle 2 ("H" - Table 2 Control
panel) buttons respectively to decrease/increase
the value.
4. Press the button ("L" - Table 2 Control panel) to
store the set value and return to parameter selec-
tion (see point 1).
For example, to adjust the parameter
follows:
24
Value (*)
G-L
dun
2,00 g/l
dIn
0,12 g/l
rIn
2,00 g/l
dEt
0,12 g/l
rAi
dIn
, proceed as
• access the programming mode
• access the dispenser family
• Select the parameter dIn
• modify the parameter value
- +
Press the button ("L" - Table 2 Control panel) to store
the set value.
To exit the programming mode, press the Wash cycle
3 button ("I" - Table 2 "Control panel").