Table of Contents
Advertisement
• YELLOW container for cutlery: insert items, with the
handles pointing downwards, in each container.
K
MACHINE CLEANING AND MAINTENANCE
K.1
Machine cleaning
Cleaning must be carried out after every day of use. Use hot
water, a neutral detergent/cleaner if necessary, and a soft
brush or sponge. If another type of detergent is used, carefully
follow the producer's instructions and observe the safety rules
given in the information sheets provided with the product or
substance.
In order to reduce the environmental impact of pollutants it is
advisable to clean the machine (externally and, where
necessary, internally) with products that are more than 90%
biodegradable.
CAUTION
Do not use steel wool or similar material to
clean stainless steel surfaces. Do not use
detergents containing chlorine.
WARNING
When using chemicals, comply
with the safety notes and dosage
recommendations printed on the
packaging. Refer to the chapter
B.11 Personal protection equip-
ment
for
products.
K.2
End of service and daily internal
cleaning
The appliance is designed to carry out an automatic cleaning
cycle to help flush out any residues and to guarantee greater
health and hygiene:
• Lift the hood and take out the rack containing the clean
dishes.
In versions without supplementary filtering system
(see below picture, detail "B")
1. Remove the flat filter "1" and the overflow "2" if present.
2. Close the hood and select the drain cycle by pressing
"Drain/Self cleaning" button.
3. At the end of the drain cycle, remove and clean the pump
suction filter "3".
26
handling
chemical
30°C
86°F
Available as accessories: dividers for glasses and rack for
dishes with maximum diameter of 320 mm.
NOTE!
if only one type of dish rack is to be used, it is
advisable to choose the GREEN rack.
In versions with supplementary filtering system
(see below picture, detail "A")
1. Remove the basket filter "1", the flat filter "2".
2. Close the hood and select the drain cycle by pressing
"Drain/Self cleaning" button.
3. Wait for almost 10 seconds and lift the hood again to
remove the tank filter "3".
4. Close the hood to restart the drain cycle. At the end of the
drain cycle, remove and clean the pump suction filter "4".
In versions with automatic hood and supplementary
filtering system
(see below picture, detail "A")
1. Remove the basket filter "1", the flat filter "2".
2. Close the hood by pressing button "A".
3. Close the hood and select the drain cycle by pressing
"Drain/Self cleaning" button.
4. Wait for almost 10 seconds and deactivate the drain cycle
by pressing again the same button.
5. Lift the hood again by pressing button "B" to remove the
tank filter "3".
6. Close the hood and select again restart the drain cycle by
pressing the same button.
7. At the end of the drain cycle, remove and clean the pump
suction filter "4".
A
• The message "CLE" (CLEAN) will be displayed throughout
the drain cycle.
• After a few minutes, 3 beeps indicate the end of the
cleaning cycle and "END" blinks on the display.
1
2
3
1
4
2
B
3
Advertisement
Table of Contents
