H3C S3100 Series Operation Manual page 8

Operation Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Figure 1-5 Sending file page
Step 9: After the sending process completes, the system displays the following
information:
Loading ...CCCCCCCCCC done!
Step 10: Reset HyperTerminal's baudrate to 9600 bps (refer to Step 4 and 5). Then,
press any key as prompted. The system will display the following information when it
completes the loading.
Bootrom updating.....................................done!
Note:
If the HyperTerminal's baudrate is not reset to 9600 bps, the system prompts "Your
baudrate should be set to 9600 bps again! Press enter key when ready".
You need not reset the HyperTerminal's baudrate and can skip the last step if you
have chosen 9600 bps. In this case, the system upgrades the Boot ROM
automatically and prompts "Bootrom updating now.....................................done!".
III. Loading host software
Follow these steps to load the host software:
Step 1: Select <1> in BOOT Menu and press <Enter>. The system displays the
following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
1-7
Chapter 1 Boot ROM and Host
Software Loading