Displaying Debugging Status; Displaying Operating Information About Modules In System - H3C S3100 Series Operation Manual

Operation Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches

2.3.2 Displaying Debugging Status

Table 2-4 Display the current debugging status in the system
Operation
Display all
enabled
debugging on the
switch

2.3.3 Displaying Operating Information about Modules in System

When an Ethernet switch is in trouble, you may need to view a lot of operating
information to locate the problem. Each functional module has its corresponding
operating information display command(s). You can use the command here to display
the current operating information about the modules in the system for troubleshooting
your system.
Table 2-5 Display the current operation information about the modules in the system.
Operation
Display the current
operation
information about
the modules in the
system.
Command
display debugging [ unit unit-id ]
[ interface interface-type
interface-number ]
[ module-name ]
Command
display
diagnostic-inform
ation
2-4
Chapter 2 Basic System
Configuration and Debugging
Description
You can execute the
display command in any
view.
Description
You can use this command in any
view.
You should execute this command
twice to find the difference between
the two executing results, thus helping
locate the problem.