H3C S3100 Series Operation Manual page 21

Operation Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Figure 2-1 The relationship between the protocol and screen debugging switch
Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Operation.
You can use the following commands to enable the two switches.
Table 2-3 Enable debugging and terminal display for a specific module
Enable system debugging
for specific module
Enable terminal display
for debugging
Caution:
The output of debugging information affects the system operation. Disable all
debugging after you finish the system debugging.
Operation
debugging module-name
[ debugging-option ]
terminal debugging
Command
2-3
Chapter 2 Basic System
Configuration and Debugging
Description
Required
Disabled for all modules
by default.
Required
Disabled by default.