Setup Procedures (Hardware); I Setup Procedures; I Mode Switch Setting - Panasonic WV-CU650 Operating Instructions Manual

SETUP PROCEDURES (HARDWARE)

I Setup Procedures

Perform the setup as follows.
1. Set the MODE switches.
You will set up the communication mode and line termi-
nation ON/OFF of RS-485 communication. (Refer to
MODE Switch Setting.)
2. Set CONTROLLER NO. switches.
You will perform this setting when using two or more
system controllers in daisy chain connections. (Refer to
p. 25 CONTROLLER NO. Switch Setting.)
3. Perform WV-CU650 setups after entering the adminis-
trator password.
You will perform the settings concerning password and
communication between system controllers and other
system units, etc. (Refer to p. 26.)
Note: Before performing WV-CU950/650 setups, you need
to log into the system by entering the administrator
password. (Refer to p. 26.)

I MODE Switch Setting

You will perform the setting of the MODE switches at the
rear panel.
Notes:
• Before the setting, turn off the system controller. (Refer
to p. 36 Power-off.)
• Do not move the MODE switches to positions other than
described in these illustrations. That may cause mal-
function.
G Setting for PS·Data Mode
If using only one system controller
Set the MODE Switch #5 to ON.
OFF
ON
MODE Switch #5 (Line termination switch)
If using two or more system controllers in
daisy chain connections
1. Set the MODE Switch #5 of the system controller at the
chain end to ON.
24
1 2 3 4 5 6 7 8
2. Set the Line termination switch of other system con-
trollers to OFF.
1 2
OFF
ON
System units
Line termination ON
Line termination OFF
Line termination OFF Line termination OFF Line termination ON
G Setting for Terminal Mode
Set the MODE Switch #1 and #5 to ON.
1 2 3
OFF
ON
Note: Refer to the operating instructions of connected
devices for details on connections and operations.
G Setting for Connection with Central
Processing Unit
(WJ-MPU955 Series/WJ-MPU855 Series/
WJ-MPU850 Series)
Terminal mode
Note: Refer to "Setting for Terminal Mode" in this page for
the switch setting.)
Ethernet mode
To apply this mode, set the MODE Switch #4 and #5 to ON.
1 2 3
OFF
ON
Note: Refer to the operating instructions of connected
devices for details on connections and operations.
3 4 5 6 7 8
4 5 6 7 8
4 5 6 7 8