I Lcd/Buzzer Adjustment; I Operation Start (Login) - Panasonic WV-CU650 Operating Instructions Manual

I LCD/Buzzer Adjustment

You can perform the settings of LCD brightness, LCD con-
trast, alarm buzzer, or button buzzer as follows.
1. Press the ADJUST button to select a desired menu.
Every pressing the button will display the brightness
setting menu → contrast setting menu → alarm buzzer
setting menu → button buzzer setting menu inter-
changeably.
Note: If no adjustment has been performed for 5 sec-
onds or more, these setting menus will automatical-
ly disappear and the LCD will return to the default
status.
2. After adjustment, press the MON (ESC) or EXIT button.
The LCD display will return to the default status.
LCD Bright
G Brightness Level Adjustment
You can change the brightness level by rotating the
JogDial.
Adjust the LCD brightness level while watching the LCD.
Note: 1 (lowest) to 20 (highest) are available. The factory
default is 14.
G Contrast Level Adjustment
You can change the contrast level by rotating the JogDial.
Adjust the contrast level while watching the LCD.
LCD Contrast
Note: 1 (highest) to 20 (lowest) are available. The factory
default is 9.
G Alarm Buzzer Setting
You can change the duration time of alarm buzzer sound
by rotating the JogDial. Adjust the alarm buzzer setting
while watching the LCD.
Buzzer Alarm
Note: OFF, 1s (second), 2s, 3s, 4s, ..., 30s, 40s, 50s, and
60s are available. The factory default is 2s.
38
G Button Buzzer Setting
You will perform the setting whether to activate a sound
when a button is pressed. Select the desired parameter by
rotating the JogDial.
Notes:
• Off or On is selectable. The factory default is On.
• If set to On, short buzzer will sound three times in the
following occasions.
(p. 17) Invalid, Prohibited
(p. 73) Level 1 Fixed

I Operation Start (Login)

14
Before starting operation, user authentication by the ID and
password is required. (Refer to p. 72 Operator Registration
or Change for details on the setting of ID and password.)
Notes:
• User authentication is skipped when the auto login is
set to ON. (Refer to p. 71.)
• If no operation has been performed for 5 seconds or
more, the LCD display will return to the login standby
display.
• The factory default of operator information is as follows.
Operator
No.
1
2
9
3
4
5
6
1. Turn on the power. (Refer to p. 36 Power-on and Power-
off.)
2. Wait until the login standby display appears.
2s
3. Press the CAM (SET) button. "User ID" entry form will
appear on the LCD.
Buzzer Operation
User ID Password
650 650
1 12345
100 100
101 101
102 102
103 103
PS·Data Mode
No User
User ID
On
Function
Camera
level
level
1 1
1 1
2 1
3 1
3 1
3 1
_____