Baud Rate Setting - Panasonic WV-CU650 Operating Instructions Manual

5. Select an item you wish to set up by rotating the
JogDial.
Baud rate
PS Data Com. Setup
•
Baud Rate
The speed of communication between the system controller
and other system units
Parity bit
PS Data Com. Setup
•
Parity Bit None
The parity bit, added to the data, to perform parity check
(Refer to p. 29 for details.)
Stop bit
PS Data Com. Setup
•
Stop Bit 1
The stop bit, added to the last of data, in asynchronous
communication (Refer to p. 29 for details.)
Wait time
PS Data Com. Setup
•
Wait Time
The wait time until the data is sent again (Refer to p. 29 for
details.)
Controller group address
PS Data Com. Setup
•
Cnt G—Adr. A
(No need for setup) Remain the factory default.
28
9600
Off
System unit group address
PS Data Com. Setup
•
Sys G—Adr.
(No need for setup) Remain the factory default.
6. Perform the settings.
Setting procedures differ depends on items. Refer to p.
28 to 30 for how to operate.
7. After you have completed the settings, turn off the
power.
G Baud Rate Setting
1. Select "Baud Rate" by rotating the JogDial.
(Refer to Step 5 in Operation.)
2. Press the CAM (SET) button.
The LCD display will change from the display mode to
the editing mode.
PS Data Com. Setup
•
Baud Rate
3. Select a desired parameter by rotating the JogDial, or
pressing the + or – button.
You can select the desired parameter from "19200",
"9600", and "4800". The factory default is "9600".
PS Data Com. Setup
•
Baud Rate
Note: Conform this parameter to the baud rate of other
system units. Otherwise, communication will not be
established between the system controller and sys-
tem units.
4. Press the MON (ESC) button.
The selected parameter will be determined, and the
LCD display will return from the editing mode to the dis-
play mode.
PS Data Com. Setup
•
Baud Rate
9600
4800
4800