Troubleshooting - Panasonic WV-CU650 Operating Instructions Manual

TROUBLESHOOTING

Check the following before requesting repair.
If a trouble cannot be corrected even after checking and trying remedy, contact your dealer.
Problem
The power of system controller is not
turned on.
The brightness of LCD is not enough. /
Characters do not appear on the LCD.
Login standby display does not appear
on the LCD.
Users cannot control cameras with the
3D joystick.
Panning, tilting, or zooming is activated even
when you are not controlling the 3D joystick.
The speed of panning and tilting is not equal
depending on directions.
Users cannot log into the system.
Check item and Remedy
The AC adapter may be disconnected
from either the system controller or the
AC outlet. Check the connection.
The DC plug may not be firmly plugged
into the DC 9 V Input jack of system
controller. Check the connection.
The display setting value of LCD may
be improper. Check the setting.
The settings of MODE switches at the
rear panel may be wrong. Check the
settings and turn on the power again.
The setting of CONTROLLER NO.
switch may be wrong. Check the setting
and turn on the power again.
You may have turned on the power
while some buttons of system controller
was held down. Check no buttons are
being held down, and turn on the power
again.
The cable may be disconnected from
either the main unit or 3D joystick unit.
Check the connection.
Users who have logged into the system
may not be authorized to control cameras
with the 3D joystick. Check the user level
settings of these users.
The combination codes of main unit
and 3D joystick unit may not be identi-
cal. Check their combination codes.
Cables may be disconnected from
either the DATA ports of system con-
troller or other system units. Check the
connections.
The line termination settings of MODE
switches may be wrong. Check the set-
tings and turn on the power again.
You may have entered a wrong user ID.
Reenter the user ID correctly.
You may have entered a wrong pass-
word. If the password is wrong, the
LCD will return to the login standby dis-
play. Reenter the password correctly.
Reference
Refer to p. 36.
Refer to p. 36.
Refer to p. 38.
Refer to p. 24.
Refer to p. 25.
Refer to p. 36.
Refer to p. 21.
Refer to pp. 72 to 76.
Refer to p. 21.
Refer to p. 20.
Refer to p. 24.
Refer to pp. 38 and 39.
Refer to pp. 38 and 39.
85