Unit Selection; I System Unit Selection; I Recorder Selection - Panasonic WV-CU650 Operating Instructions Manual

UNIT SELECTION

To control the system, you need to select a desired unit
(system unit, recorder, monitor, or camera) at the begin-
ning.

I System Unit Selection

Notes:
• In advance, you need to set the unit number for each
system unit. (Refer to the operating instructions of sys-
tem units.)
• 1 to 99 are available for the unit number.
1. Enter a unit number by pressing the numeric buttons.
The entered number will appear on the LCD.
Mon01 Cam016
F1 F2
2. Press the RECORDER/UNIT button while holding down
the SHIFT button. The system will become ready for
control. Then, the monitor number, camera number,
and system unit number will appear on the LCD.
Mon02 Cam016
F1 F2
Note: Three seconds after, model number will appear
in place of unit number. To display the unit number
again, hold down the RECORDER/UNIT.
Mon02 Cam016
F1 F2
• If you have entered a wrong unit number, "Invalid"
will appear on the LCD. Then, the LCD will return to
the status before the system unit selection.
Invalid
___16
F3 F4
Unit16
F3 F4
HD316
F3 F4

I Recorder Selection

Notes:
• In advance, you need to set HDD-unit maps. (Refer to
p. 78 Associating Recorder Numbers with Unit
Numbers.)
• In the factory default, Recorder 1 to 16 is associated
with Unit 1 to 16.
1. Enter a recorder number by pressing numeric buttons.
The entered number will appear on the LCD.
Mon02 Cam128
F1 F2
2. Press the RECORDER/UNIT button. The system will
become ready for control, and the monitor number,
camera number, and system unit number will appear on
the LCD.
Mon02 Cam016
F1 F2
Notes:
• Three seconds after, model number will appear in
place of unit number.
Mon02 Cam016
F1 F2
• If you have entered a wrong recorder number,
"Invalid" will appear on the LCD. Then, the LCD will
return to the status before the recording selection.
Invalid
____2
F3 F4
Unit16
F3 F4
HD316
F3 F4
41