Table of Contents
Advertisement
Set which effect is applied to the bus beforehand. For details, refer to
1.
Press the [BUS FX] button to select BUS 2.
2.
Hold down the [REMAIN] button and press the pad [1].
The playback audio for the sample assigned to pad [1] is sent to the effect assigned to BUS 2.
Pad [1] lights up green at this time.
The pad's color tells you the bus to which the sample is sent.
Pad color
Lit orange
Lit green
Lit white
Preventing samples from being sent to BUS 1/BUS 2
You can prevent the playback audio of samples from being sent to BUS 1 or BUS 2 (DRY). In this case, no effects are applied to the
samples.
1.
While holding down the [REMAIN] button, press the pad [1]–[16] buttons a number of times to make
them light up white.
The BUS 1 and BUS 2 effects are not applied to the samples of pads that are lit up white.
Sending the audio input from the INPUT jack to a bus
As with the samples, you can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which
effects are used).
For details, refer to
"Sending the Audio Input from the INPUT Jack to a
Using the MFX Effects
You can select and use the effects you like for the MFX effects.
1.
While holding down the [MFX] button, turn the [VALUE] knob or the [CTRL 3] knob to select the effect to
use.
You can also use pads [1]–[16] instead of the [VALUE] knob or the [CTRL 3] knob to select an effect.
To use pads [1]–[16] to select effects from #17 and up, hold down the [MFX] button and the [DJFX LOOPER] button at the same
time.
2.
After selecting the effect, take your finger off the [MFX] button.
The effect turns on, and the effect edit screen appears.
3.
Play back a sample.
4.
Use the [CTRL 1]–[CTRL 3] knobs to adjust the parameters.
BUS 1
BUS 2
The sound is not sent to BUS 1 or BUS 2 (DRY).
"Assigning Effects to BUS 1 and BUS
Audio send destination (bus)
Bus(P.113)".
Using the Effects
2(P.30)".
31
Advertisement
Table of Contents
