Editing A Sample In Dj Mode - Roland SP-404MKII Manual

Mixing the Samples (DJ MODE)

Editing a Sample in DJ Mode

You can edit the samples that are used in DJ mode.
1. Press the [VALUE] knob.
A menu appears.
2. Use the [VALUE] knob to select "CH1 EDIT" or "CH2 EDIT," and press the [VALUE] knob.
The sample edit screen appears. The editing method is the same as for sample edit in sample mode.
Controller
[CTRL 1] knob
[CTRL 2] knob (when the
loop is on)
[CTRL 3] knob
[SHIFT] button + [CTRL]
knob (turn)
[VALUE] knob (turn)
[VALUE] knob (press)
[SHIFT] button + [VALUE]
knob (turn)
[DEL] button
[REMAIN] button
[ROLL] button
94
Moves the start point.
Moves the loop point.
Moves the end point.
Zooms the area around each point in/out.
Zooms the area in/out around each point you just manipulated.
You can use a numerical value to set the position of each point.
Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the
position (press pad [10] to input a "0").
To confirm the inputted position, press the [VALUE] knob.
Adjusts the volume of the channel.
Initializes the start and end point positions.
●
When a confirmation message appears, use the [VALUE] knob to select "OK," and
press the [VALUE] knob.
On: Prevents the start point from being moved beyond the loop point or the end point.
Off: When the start point moves beyond the loop point or the end point, this moves the
loop point or the end point as well.
While this button is pressed, you can preview the sound several seconds before the end
point.
Action