Table of Contents
Advertisement
Mixing the Samples (DJ MODE)
Adding a Marker While Playing Back a Sample
You can add markers while playing samples in DJ mode.
1.
Play back a sample.
2.
Hold down the [SHIFT] button and press the [MARK] button at the position where you want to add a
marker.
This adds a marker to the sample.
You can add up to seven markers.
Editing a Marker While Playing Back a Sample
You can edit markers while playing samples in DJ mode.
1.
Press pad [13] or [15].
The corresponding samples play back.
2.
Hold down the [SHIFT] button and press the [START/END] button.
The marker edit screen appears.
Controller
[MARK] button
[CTRL 1] knob
[CTRL 2] knob
[CTRL 3] knob
[SHIFT] button + [CTRL]
knob (turn)
[VALUE] knob (turn)
[VALUE] knob (press)
[SHIFT] button + [VALUE]
knob (turn)
[DEL] button + pads [1]–
[8]
[RESAMPLE] button
[ROLL] button
Pad [13]
Pad [9]
92
Adds a marker.
Moves the cursor.
Moves the marker.
Selects a marker.
Zooms the area around each point in/out.
Zooms the area in/out around each point you just manipulated.
You can use a numerical value to set the position of each point.
Use the [VALUE] knob to select the point to set, and press pads [1]–[10] to input the position (press
pad [10] to input a "0").
To confirm the inputted position, press the [VALUE] knob.
Adjusts the volume of the channel.
Deletes the marker.
Moves the start point to the zero cross-point (*) that's closest to the start point time (SNAP to Zero-
Cross function).
Similarly, the loop point and end point are also moved.
This function is enabled when the [RESAMPLE] button is lit.
* The "zero cross-point" is the time at which the value of the sample waveform crosses from zero
into a positive or negative number.
While this button is pressed, you can preview the sound several seconds before the end point.
Switches between play/pause.
Returns to the playback start position.
Action
Advertisement
Table of Contents
