Roland SP-404MKII Manual page 128

Appendix
Parameter
Filter+Drive, Resonator, Sync Delay, Isolator, DJFX Looper, Scatter, Downer, Ha-
Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo, TimeCtrlDly, Super
Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Reverb,
Direct FX1– Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, Chromatic PS,
Direct FX5 Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer, Compressor, SX
Reverb, SX Delay, Cloud Delay, Back Spin
OTHER
Parameter
This individually selects the bus to mute with MUTE BUS.
ALL
Mute Bus
BUS
Bypass, Auto Pitch (*), Vocoder (*), Gt Amp Sim (*), Harmony (*), Chorus, JUNO
Chorus, Reverb, TimeCtrlDly, Chromatic PS, Downer, WrmSaturator, 303 VinylSim,
404 VinylSim, Cassette Sim, Lo-fi, Equalizer, Compressor
Input FX Effects marked with an (*) are for INPUT FX only.
You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which
effects are used).
DRY
Input Bus
BUS1, BUS2
This sets the routing for audio sent to the DRY bus.
DRY DRY
Routing
BUS3
Scatter, Downer, Ha-Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo,
TimeCtrlDly, Super Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim,
Lo-fi, Reverb, Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan,
MFX TOP Chromatic PS, Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer,
Compressor, SX Reverb, SX Delay, Cloud Delay, Back Spin
128
Value
Value
Explanation
You can assign the
effects you like to the
effect buttons on the
top panel.
For details on the
parameters of each
effect, refer to "MFX
List(P.129)".
Explanation
Both BUS 1 and BUS 2
are muted.
Only the bus selected
with the [BUS FX] button
is muted.
You can apply effects to
the audio that's inputted
to this unit.
For details on the
parameters of each
effect, refer to "MFX
List(P.129)".
The signal is not sent to
BUS 1, BUS 2 (the BUS 1
and BUS 2 effects are not
used).
The signal is sent to BUS
1 or BUS 2. The effects
set for BUS 1 and BUS 2
are used.
Audio is not sent
through BUS 1–BUS 4
(no effects are applied).
Audio is inserted just
before BUS 3. The BUS 3
and BUS 4 effects are
applied.
Sets the MFX that's used
when this unit is turned
on.
For details on the
parameters of each
effect, refer to "MFX
List(P.129)".