Fcc Notices - Digi XB3-C-G1-UT-001 User Manual

Xbee 3 cat 1 smart modem

Hide thumbs Also See for XB3-C-G1-UT-001:

Table of Contents

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: Re-orient or relocate the receiving antenna,

Increase the separation between the equipment and receiver, Connect equipment and receiver to

outlets on different circuits, or Consult the dealer or an experienced radio/TV technician for help.

RF exposure

CAUTION! This equipment is approved for mobile and base station transmitting devices only.

Antenna(s) used for this transmitter must be installed to provide a separation distance of at

least 21 cm from all persons and must not be co-located or operating in conjunction with any

other antenna or transmitter.

FCC notices

IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107

& 15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.

IMPORTANT: The RF module has been certified for remote and base radio applications. If the module

will be used for portable applications, the device must undergo SAR testing.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.