Modification Statement; Interference Statement; Fcc Class B Digital Device Notice - Digi XB3-C-G1-UT-001 User Manual

Regulatory Information
This section lists the regulatory information required by the Federal Communications Commission
(FCC).
For ISED regulatory information, see

Modification statement

Digi International has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user's authority to operate the equipment.

Interference statement

This device complies with Part 15 of the FCC Rules and ISED (Innovation, Science, and Economic
Development Canada) license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.

FCC Class B digital device notice

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the receiver is
n
connected.
Consult the dealer or an experienced radio/TV technician for help.
n
IMPORTANT: The RF module has been certified for mobile and base radio applications.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Digi XBee® 3 Cat 1 Smart Modem User Guide
Regulatory Information: ISED.
333