Removing The Heater Lamp Control Board - Minolta magicolor 7300 Service Manual

FrameMaker Ver.6E (PC) magicolor 7300 ASSEMBLY/DISASSEMBLY
02.08.08
4134D063AA
4134D064AA
4134D065AA
(6)

Removing the Heater Lamp Control Board

1. Remove the Left Cover.
2. Remove the Panel Cover.
3. Remove the Top Cover.
4. Remove the Rear Cover.
4134D030AA
9. Remove all of the connectors on the Print Unit
Drive Motor Bk/YMC Board.
10. Remove the Interface Connector for the 1st
Image Transfer Pressure/Retraction Clutch.
11. Remove two screws.
12. Remove the flat cable, and the First Drawer
Paper Size Detecting Board.
5. Unplug all connectors on the Heater Lamp Con-
trol Board.
6. Remove two screws, and the Heater Lamp Con-
trol Board.
D-15