Kraus Oletto KPF-2631 Installation Manual page 10

Step 6: Flush faucet
1
A
NOTE: Please make sure the
washer (1) is installed before
attaching the spray head to the
hose.
10
Pull the hose assembly out of the spout
and remove the spray head (A) by
unscrewing it from the hose in a
counterclockwise direction. Be sure to
hold the end of the hose down into the
sink and turn the faucet on to the warm
position where it mixes hot and cold
water. Flush the water lines for one
minute. This flushes away any debris
that could cause damage to internal
parts. Check for leaks. Retighten any
connections if necessary, but do not
overtighten. Reinstall the spray head (A)
by hand tightening it back onto the
sprayer hose. After installation is
completed, turn on the hot and cold
water supplies. Check for leaks.