Respironics SmartMonitor 2 Service Manual page 56

Verification of Respiration Signal Sensitivity
Simulator Setting for test Set up
ECG Beats/Min 200
ECG AMPL/MV 0.5
Test Point Simulator Setting
Resp. Breath/Min
1 Variation OHMS
Resp. Breath/Min
2 Variation OHMS
3 Variation OHMS
Resp. Breath/Min
4 Variation OHMS
5 Variation OHMS
Resp. Breath/Min
6 Variation OHMS
7 Variation OHMS
Resp. Breath/Min
8 Variation OHMS
9 Variation OHMS
Resp. Breath/Min
10 Variation OHMS
Resp. Breath/Min
11 Variation OHMS
Simulator Setting for Test Set Up
ECG Beats/Min 85
ECG AMPL./MV 0.5
Resp. Breath/Min
12 Variation OMS
1007897
Apnea Should Occur Approximately 20 Seconds after last respiration detection.
Detection Apnea Alarm
10
1 YES
15
0 NO
1 YES
30
0 NO
0.2 YES
50
0 NO
0.2 YES
75
0 NO
1 YES
100
1 YES
120
1 YES
150
2 YES
SmartMonitor 2 Service Manual
There are 14 test points that require
different simulator settings. For each test
point, make the required changes as listed in
Pass
the following table and verify the appropriate
SmartMonitor 2 response. A Simulator
NO
setting value that changes the same from the
YES
previous Test Set Up are in BOLDED
NO
TEXT. Press the RESET button on the
SmartMonitor 2 to reset any alarm faults.
YES
NO
YES
NO
recognition circuitry of the SmartMonitor 2
YES
NO
may activate and cuase brief pauses in
detection. Once normal signal detection
NO
by the monitor resumes, allow and addi-
tional 10 seconds for the detection circuits
NO
to stabilize before proceeding with verify-
ing the operation of the SmartMonitor 2.
After a change in rate, it will take an
additional 10-30 seconds for the rate
display to reach its specified value.
NO
Chapter 8: Verification
Due to large signal changes that
result when Simulator settings are
initially changed, the off-scalesignal
8-9