Respironics SmartMonitor 2 Service Manual page 18

Modem Auto Dial
•
Plug the telephone wire into the modem connector on the
back of the SmartMonitor .
•
Plug the other end of the phone wire into the wall phone
jack.
Refer to the Synergy-E™ software for instruction on receiving a
call from the SmartMonitor 2.
Modem will continue calling every 30 minutes, for 4 hours until it
connects with the computer. If no connection is made, the modem
will try again the next day at the pre-selected time. For example, if
the modem is programmed to call at 7am but fails to make a
connection after 8 attempts it will stop trying. The next day at 7am
it will try again. This will continue until a connection is made.
Modem Auto Answer in communications Mode
•
•
SmartMonitor 2 Service Manual
Chapter 4: Installation and Setup
Connect a phone cord from the wall jack to the modem connector on
the back of the SmartMonitor 2.
To allow the SmartMonitor 2 to work with the modem, place the monitor
in Communications Mode:
• Press and hold the blue RESET button.
• Press and release the POWER button.
• Wait until the monitor alarms. Now release the RESET
button.
• Briefly press and release the RESET button again.
• The SmartMonitor 2 beeps every 10 seconds whenever it
is in the Communications Mode. This is a reminder that the
SmartMonitor 2 is powered on for working with the
computer, memory card, or modem, but not for monitoring the
infant.
Do nto connect the infant to the SmartMonitor 2 when in the
Communications Mode, the spnea and heart rate alarms are not
operational in this mode.
• The dealer should now call to retrieve the information. The
phone may ring, but do not answer. The modem answers
the call and connects the SmartMonitor 2 to the computer
through the phone line.
4-5