Table of Contents
Advertisement
Installation
Adjustable plinth panel
(depending on the model)
Dishwashers with internal dispensing or
active drying have an adjustable plinth
panel.
Level the dishwasher.
Open the dishwasher door halfway and
loosen the two screws now visible at the
top of the plinth panel.
Pull the plinth panel upwards first and
then forwards.
Loosen the two screws on the right and
left of the plinth behind the panel.
Pull the inside of the plinth down to the
floor.
Tighten the two screws again.
Reassemble the plinth panel by following
the instructions above, but in reverse
order.
Removing the machine lid
If the dishwasher is fitted with a lid, it can be
removed as follows:
Remove both securing screws on the
back of the dishwasher with a screwdriver.
Open the door.
Unscrew the left and right fastening
screws with a screwdriver.
Lift the machine lid upwards to remove.
102
Levelling and securing the
dishwasher
To guarantee stability, the dishwasher must
be secured to the worktop after levelling.
After levelling, secure the dishwasher to
the continuous worktop.
With the door open, screw into the
worktop through the holes in the front trim
on the left- and right-hand sides of the
dishwasher.
With stainless-steel or stone worktops, the
dishwasher must be secured at the sides to
the left and right adjacent cupboards with
two screws on each side.
Special screws (4 x 27/Torx T20) are
supplied in the accessory pack.
Holes must be drilled in the side wall in front
of the door seal for this.
In the case of built-under dishwashers, the
holes are already provided in the side walls.
The gaps between built-under dishwashers
and adjacent cabinets or machines must
not be filled with silicone sealant as this
could compromise the ventilation of the
circulation pump.
Advertisement
Table of Contents
