Table of Contents
Advertisement
Opening and closing the door
Door lock
Depending on the model, the dishwashers
are equipped with a comfort door lock with
electronic door locking or a pull-open lock.
Dishwashers with a comfort door lock have
a door button on the control panel. This
button is not available on machines with a
pull-open lock.
Comfort door lock
The door of the wash cabinet is equipped
with a Comfort door locking mechanism.
When the door is closed, the Comfort door
locking mechanism automatically pulls the
door into the closed position and thus
ensures it is sealed. The door is locked
electronically.
Open the door
A door that has been locked electronically
can be opened under the following
circumstances:
- The machine is connected to the power
supply and switched on (the LED is lit
up)
- The LED is lit.
Press the button to open the door.
If the temperature in the wash cabinet
exceeds 67 °C, a message is shown on the
display:
Hot wash cabinet: Risk of injury, take
care when opening the door.
Press the button again to open the door.
The comfort door lock opens the door
slightly. The LED in the button goes out as
soon as the door is unlocked.
The dishwasher's control panel is also a
door handle.
Grasp the handle underneath the control
panel and pull the door down to open it.
24
.
Closing the door
Make sure that no objects or load items
protrude into the closing area of the door.
Risk of injury caused by crushing.
Do not put your hand inside the door as it
is closing. Risk of crushing.
Raise the door upwards until the catch
engages.
The door will be drawn into its final close
position if the AutoClose function is
activated (see "AutoClose").
Opening the door using the emergency
release
The emergency release may only be used
when it is no longer possible to open the
door normally, e.g. in the event of a power
failure.
Danger of scalding, burning and
chemical burns!
If the emergency release is operated
during a programme sequence, hot water
and process chemicals can escape.
Only open the door using the emergency
release when strictly necessary.
The emergency release mechanism is
located on the right beside the door lock in
the gap between the door and the lid of the
machine or the worktop.
There should be 1 cm between the right
edge of the tool and the right edge of the
display.
Press against the door to release the
emergency release mechanism.
1 cm
Advertisement
Table of Contents
