Table of Contents
Advertisement
5. 3600: Keeping downward pressure on the blade and applicator, rotate
the two knobs to tighten the blade.
3505/3700/3800/3805: Keeping downward pressure on the blade and
applicator, tighten the two blade retaining screws.
6. Use the thickness gauges to confirm that the blade is set to the correct
gap. Adjust if necessary.
The applicator is now ready for use.
3 APPLICATION PROCEDURE
Before each use, check the working surfaces for irregularities and damage.
3505/3600/3700
1. Fix a clean substrate on a flat and horizontal base such as a vacuum table.
2. 3505 only: If applying a film to a glass substrate, fit the guide plate to the side of the applicator.
3. Place the applicator down at one end of the substrate. The applicator should be positioned with the
blade facing away from the direction of travel.
4. 3600: Spread sufficient product on the substrate over a width slightly smaller than the internal width of
the applicator.
3505/3700: Pour a quantitiy of product into the reservoir of the applicator ensuring that the product is
evenly distributed over the whole width of the reservoir.
5
Advertisement
Table of Contents
