Volvo VN Service Manual page 27

Group 18 Rustproofing
21
Open luggage door. Remove the com-
partment light switch from the C-pillar.
Insert the application wand in the
switch hole forward into the bottom rail
cavity. The total length of the wand
should be inserted.
Fully depress the spray gun trigger,
then slowly pull the application wand
back out from the bottom rail at the
determined speed. Release the spray
gun trigger as soon as the tip of the
wand appears at the switch hole.
22
Insert the application wand through
the switch hole up into the C-pillar, to
a height of a minimum position of 400
mm
(1 1/3 ft) into the cavity.
Fully depress the spray gun trigger
then slowly pull the application wand
back out from the bottom rail at the
determined speed. Release the spray
gun trigger as soon as the tip of the
wand appears at the switch hole. In-
stall the compartment light switch.
23
Coat the lower luggage compartment
W1000106
hatch cavity with cavity wax up to
Torx 25,
50 mm (2 in.) from the bottom. With
Cavity wax
the application wand inserted in the
spray kit
hatch cavity, move the wand as neces-
sary to ensure complete coverage. Tilt
the hatch downward while applying the
wax so gravity can assist in letting the
wax flow to the lower portions of the
cavity profile. Close the hatch immedi-
ately after application.
24
Repeat all above steps on the oppo-
site side of the cab.
Note: To avoid the wax drying in the
equipment, always thoroughly clean
the cavity wax spray kit with white
spirit after each use.
W1000107
Torx 25,
Cavity wax
spray kit
Service Procedures
W1000108
25