Volvo VN Service Manual page 23

Group 18 Rustproofing
4
Remove the door switch for the interior
light. Insert the application wand in
through the switch hole forward into
the bottom rail cavity. The total length
should be inserted.
Fully depress the spray gun trigger
then slowly pull the application wand
back out from the bottom rail at the
determined speed. Release the spray
gun trigger as soon as the tip of the
wand appears at the door switch hole.
5
Insert the application wand up the
B-pillar through the door switch hole,
to a minimum position of 400 mm
(1 1/3 ft) up the cavity.
Fully depress the spray gun trigger,
then slowly pull the application wand
back out from the B-pillar at the deter-
mined speed. Release the spray gun
trigger as soon as the tip of the wand
appears at the door switch hole. Install
the light switch.
6
Insert the application wand in through
the switch hole rearward into the bot-
tom rail cavity. The total length should
W1000101
Torx 25,
be inserted.
Cavity wax
spray kit
Fully depress the spray gun trigger,
then slowly pull the application wand
back out from the B-pillar at the deter-
mined speed. Release the spray gun
trigger as soon as the tip of the wand
appears at the door switch hole. Install
the light switch.
7
W1000102
Torx 25
Cavity wax
spray kit
Remove the side repeater lamp lens
and base. Coat the cavity behind the
lamp. Move the wand as necessary to
ensure complete coverage, both on
the bottom and the panel side. Install
the repeater lamp.
Service Procedures
W1000103
W1000104
Philips,
Torx 25,
Cavity wax
spray kit
21