Volvo VN Service Manual page 16

Group 18 Rustproofing
12
Sleeper cabs only:
Open luggage door. Locate the vent in
the rear end of door frame. With a
knife blade or small screwdriver, pry
out the center section. Do this by push-
ing the blade in between vent and grill
and push the grill to the side so the
lock tabs release. Pry out the lock tabs
for the vent (2 per side) and remove
the vent. Inspect the lower part of the
C-pillar for signs of rust. Install vent.
13
Inspect the lower part of the luggage
door, inner and outer skin, for signs of
rust.
14
14
W1000093
Remove plastic plugs along the inside
mirror,
of the bottom rail. Inspect for signs of
flashlight
rust on the inside of the bottom rail. In-
stall the plastic plugs.
Generally inspect the floor area under-
neath the cab. Look between the large
fore-aft member and the bottom rails
at the edge of the cab for signs of rust.
15
Repeat above steps on the other side
of the cab.
16
W1000094
Inspect the rear, lower cab edge for
signs of rust.
Service Procedures
W1000095
mirror,
flashlight
W1000097
mirror,
flashlight