Volvo VN Service Manual page 18

Group 18 Rustproofing
3
Open the door. Push back the door
wiring grommet and insert the applica-
tion wand down the A-pillar and into
the bottom rail, pointing rearward. The
total length of the wand should be in-
serted.
Fully depress the spray gun trigger
then slowly pull the application wand
back out from the bottom rail and
A-pillar at the determined speed. Re-
lease the spray gun trigger as soon as
the tip of the wand appears at the
door wiring grommet. Refit the grom-
met and adjust to a good fit.
16
4
Remove the door switch for the interior
light. Insert the application wand in
through the switch hole forward into
the bottom rail cavity. The total length
should be inserted.
Fully depress the spray gun trigger,
then slowly pull the application wand
back out from the bottom rail at the
determined speed. Release the spray
gun trigger as soon as the tip of the
wand appears at the door switch hole.
W1000100
Cavity wax
spray kit
5
Insert the application wand up the
B-pillar, through the door switch hole,
to a minimum position of 400 mm
(1 1/3 ft) up the cavity.
Fully depress the spray gun trigger,
then slowly pull the application wand
back out from the B-pillar at the deter-
mined speed. Release the spray gun
trigger as soon as the tip of the wand
appears at the door switch hole. Install
the light switch.
Service Procedures
W1000101
Torx 25,
Cavity wax
spray kit
W1000102
Torx 25,
Cavity wax
spray kit