Table of Contents
Advertisement
Step 4: Slide the remaining end of the #4354
Center Axle through the RIGHT collar. Push
through fully. Do the same process to the
other 3 sets of #4354 Center Axles and #4351
Idlers.
4352R
Idler Frame Assembly
(Upside down view)
2061
Step 5: Secure #4354 Center Axles with (1)
5/16"-18 x 1 1/4" Spin Lock Bolt and (1) 5/16"-
18 Spin Lock Nut...tighten. Insert a #2061
Grease Fitting into end of each #4354 Center
Axle...tighten. Do the same process to the
other 3 sets of #4354 Center Axles & #4351
Idlers. See picture above.
Once assembly is complete, flip over your
#4352 L & R Idler Frame Assemblies. They
should look like the below picture. Note: The
#4352R Idler Frame Assembly is shown
below.
4352R
4351
Idler Frame
Assembly
2061
4354
Step 6: Remove the (3) bolts from each side
of the body, for later re-assembly. See picture
in the next column.
5/16" Spin
Lock Bolt
& Nut
4351
Bolt
2061
For the next steps, Bolts 1, 2 and 5 are the
5/16" Bolts and nuts that you removed from
your body wall above. Bolts 3 and 4 are new
3/8" Bolts and Nuts. Having a helper avail-
able in this process to hold the assembly up
and spin on the nuts will make the process
much easier.
Step 7: Loosely, attach Bolt - 1 through the
#4352R Idler Frame Assembly, then through
the body wall. Attach a 5/16" Nut to the inside
of the body wall. See picture below.
Step 8: Loosely, attach Bolt - 2 through the
#4352R Idler Frame Assembly, then through
the bodywall. Attach a 5/16" Nut to the inside
of the body wall. See picture below.
Step 9: Loosely, attach Bolt - 3 & Bolt 4
through the LOWER HOLES on the Track Ex-
pander, then through the #4352R Idler Frame
Assembly. Attach a 3/8" Nut to the inside of
the #4352R Idler Frame Assembly. See
below.
Bolt - 5
Bolt - 2
Idler Frame Assembly
Bolt - 3
Expander
56
5/16"
Bolt - 1
4352R
3/8"
Track
Bolt - 4
Advertisement
Table of Contents
