MAGNATRAC RT1150 Operator / Technical Manual page 28

Note: There are welded nuts on the underside of
the pump mount that is closest to the operator
seat. Use the two pictures below as a guide. The
picture below shows the bolt 1 & 2 with the
welded nut on the underside. No need to hold the
nut, just loosen the 2 bolts, but do NOT remove.
1
The picture below and at the top right of the
next column shows bolt 3 & 4. The nuts are on
the underside of the "raised body pan." Note:
Using ratchet extension with socket and
wrench, have 1 person hold the nut from the
underside of the body pan, while another per-
son loosens (but doesn't remove) the bolt,
from the top. You should not need to remove
any front counterweight.
Raised
Body Pan
2
Hyd. Pump
Mount
3 4
4
Hyd. Pump
Mount
Note: If Tensioning Drive Belt, continue to Step
4. Skip to Step 9 if removing or replacing.
Step 4: Using the picture below and on the top
left of the next page as a guide, insert a long pry
bar in the area shown below. Make sure the pry
bar tip, sits firmly against the back wall of the sup-
port plate. Be careful not to damage the cooling
fans of both transaxles.
28
3