MAGNATRAC RT1150 Operator / Technical Manual page 30

Step 8: If you moved the cross braces to gain ac-
cess to the area, move cross braces back into po-
sition and tighten bolt and nuts.
Congratulations! Your install is now complete. Re-
install Rear Cover's Seat and Hood. See page 23.
DRIVE BELT REMOVAL PROCEDURE
Follow Steps 1-7 first. In these instructions, we
advise to use a pry bar to move the hydraulic
pump mount, however, if the four hydraulic pump
mounting bolts are loose enough from the previ-
ous steps, you may be able to use hand pressure
to move the hydraulic pump rearward and forward
as needed.
Step 9: Using the picture at the op of the next col-
umn as a guide, insert a long pry bar in the area
shown. Make sure the pry bar sits firmly between
the hydraulic pump mount and the engine stand.
Be careful not to damage the engine, wiring, etc.
Push Forward
Pry Bar
Hyd. Pump
Mount
Pump
Mount Pulley
Step 10: Pushing "forward on the top" of the pry
bar, will push the "bottom part of the pry bar rear-
ward," which will push the hydraulic pump mount
rearward as well. Make sure hydraulic pump
mount is as far rearward as possible.
Step 11: The drive belt should be loose enough
to now to be removed. Pull drive belt towards en-
gine and "over" the hyd. pump mount pulley.
Step 12: Then loop "over" each transaxle pulley.
Step 13: Now loop "under" the engine drive pulley,
as shown in the picture below.
Drive Belt
30
Engine Stand
Transaxle
Pulleys
Engine Drive
Pulley